There is an episode about the high frequency PCB made on RT/duroid 6002 material.

Rogers' RT/duroid 6002 high frequency material is the preferred PTFE-based ceramic composites. It is a kind of low loss and low dielectric constant laminate, which can meet the strict requirements for mechanical reliability and electrical stability in complex microwave structural design.

The dielectric constant of RT/duroid 6002 has excellent resistance to temperature change between -55 ℃ and 150 ℃, which can meet the requirements of filter, oscillator and delay line for its electrical stability.

For RT/duroid 6002 PCBs, we can provide you with single layer board, double layer board, multi-layer board and hybrid types.

RT/duroid 6002 PCBs have wide thickness. There are the standard thickness such as 10 mils, 20 mils, 30 mils and 60mils etc. and non-standard thickness such as 15 mils, 25 mils,35 mils and 40 mils etc. It’s as thin as 5 mils and as thick as 125 mils for our designers.

Finished PCB copper has 1oz and 2oz. Our maximum PCB size on high frequency material is 400mm by 500mm, it can be a single board in the sheet and also can be different designs in this panel.

Solder mask of green, black, blue and yellow etc is available in house. There’s immersion gold, HASL, immersion silver, immersion tin, bare copper etc. for pads plating.

RT/duroid 6002 PCB has tight thickness control with low out-gassing. It is very suited to the equipment of flat and non-planar structures, such as antennas, complex multi-layer PCBs with inner-layer connections, and microwave PCBs for aerospace designs in hostile environments.