• September 03. 2026

Which RF Applications Suit TF960 PCB? A Dk 9.6 Low-Loss Selection Guide Quick Answer TF960 PCB is a high-frequency laminate made from modified PTFE resin, ceramic fillers, and glass fabric. With a dielectric constant (Dk) of 9.6 ± 0.19 and dissipation factor (Df) of 0.0012 at 10 GHz, it targets RF and microwave circuits requiring low insertion loss and stable impedance. It supports 260°C lead-free...

• September 03. 2026

Dk 3.0 or Dk 10.2: Which High-Frequency Substrate Fits Your Antenna Design? Quick Answer Choose Dk 3.0 for wider traces, easier impedance control, and higher-frequency operation where dispersion matters. Choose Dk 10.2 for circuit miniaturization, compact antenna spacing, or high-Dk architectures. TFA1020, a PTFE-ceramic composite with no glass fiber, delivers Dk 10.2 at 10 GHz with Df as low as 0...

• October 22. 2026

Is a 4-Layer 8mil RO4003C Tg170 FR-4 Hybrid PCB Right for You? Every mixed-signal design eventually reaches the same decision. One section of the board carries RF or microwave traces — antenna feeds, matching networks, a front-end that must hit a defined impedance — while the rest is ordinary power and digital control. The material question follows immediately: all FR-4, all high-frequency laminat...

• October 22. 2026

How Do You Build an 8-Layer RO4350B MT40 Hybrid PCB Without Defects? A hybrid stack looks elegant on a cross-section drawing. It promises the low-loss, tightly controlled RF behavior of a ceramic-loaded hydrocarbon laminate on the outer layers, and the cost and processing familiarity of an FR-4-type low-loss material in the middle. On paper, that is exactly what an 8-Layer RO4350B MT40 Hybrid PCB ...

• October 22. 2026

How to Select 1080 Prepreg for Rogers RO3010 and FR-4 Hybrid Lamination? Introduction Hybrid multilayer PCBs that pair ceramic-filled PTFE high-frequency laminates such as Rogers RO3010 with conventional FR-4 prepreg have become a standard construction for cost-sensitive RF designs. Place the premium high-Dk material only where RF signals travel, and use economical FR-4 bonding sheets elsewhere. Y...

• October 22. 2026

Can One Rogers RO4003C 1100x350mm Double-Sided HF PCB Replace Spliced Antenna Sub-Boards? 1. The short answer Yes. When a single radiating aperture, feed network or sensor array is longer than a standard board and must stay electrically continuous, one Rogers RO4003C 1100x350mm double-sided HF PCB removes the connectors and splices that quietly degrade large antenna designs. It is not the che...