• March 24. 2026

Why Choose ENEPIG Finish Over Other Surface Finishes for a Double-Layer Rogers PCB? ENEPIG (Electroless Nickel Electroless Palladium Immersion Gold) is increasingly specified for high-performance PCBs, especially those combining RF materials like Rogers RO4003C with mixed-technology assemblies. In the double-layer board described earlier—featuring a 0.5mm RO4003C LoPro core, 1 oz copper, no bottom...

• May 19. 2026

How Does RO4350B LoPro PCB Solve Conductor Loss Issues in High-Speed Electronics? As electronic systems push toward millimeter-wave frequencies and data rates exceeding 100 Gbps, conductor loss has emerged as the single most critical bottleneck limiting performance. In 5G mmWave base stations, satellite communication payloads, and high-speed data center backplanes, even a 0.1 dB/inch increase in s...

• July 27. 2026

What Benefits Does a CuClad 250 PCB Bring to High-Frequency Circuit Design? 1.Introduction High-frequency circuit design demands substrate materials that can maintain signal integrity across microwave and millimeter-wave bands. Among the various PTFE-based laminates available, Rogers CuClad 250 has established itself as a reliable option for engineers balancing electrical performance with mechanic...

• October 22. 2026

Is a 4-Layer 8mil RO4003C Tg170 FR-4 Hybrid PCB Right for You? Every mixed-signal design eventually reaches the same decision. One section of the board carries RF or microwave traces — antenna feeds, matching networks, a front-end that must hit a defined impedance — while the rest is ordinary power and digital control. The material question follows immediately: all FR-4, all high-frequency laminat...

• October 22. 2026

How Do You Build an 8-Layer RO4350B MT40 Hybrid PCB Without Defects? A hybrid stack looks elegant on a cross-section drawing. It promises the low-loss, tightly controlled RF behavior of a ceramic-loaded hydrocarbon laminate on the outer layers, and the cost and processing familiarity of an FR-4-type low-loss material in the middle. On paper, that is exactly what an 8-Layer RO4350B MT40 Hybrid PCB ...

• October 22. 2026

How to Select 1080 Prepreg for Rogers RO3010 and FR-4 Hybrid Lamination? Introduction Hybrid multilayer PCBs that pair ceramic-filled PTFE high-frequency laminates such as Rogers RO3010 with conventional FR-4 prepreg have become a standard construction for cost-sensitive RF designs. Place the premium high-Dk material only where RF signals travel, and use economical FR-4 bonding sheets elsewhere. Y...