• December 07. 2022

RF-35 High volume commercial microwave and RF laminate Taconic RF-35 is an organic-ceramic laminate in the ORCER family of Taconic products. lt is based on woven glass reinforcement. RF-35 PCB is a result of Taconic's expertise in both ceramic fill technology and in coated PTFE fiberglass. RF-35 material is the best choice for low cost, high volume commercial microwave and radio frequency applicat...

• December 14. 2022

Taconic CER-10 RF PCB Printed Circuit Board CER-10 is an organic-ceramic DK-10 laminate in the ORCER family of Taconic products. It is based on a woven glass reinforcement. CER-10 PCB exhibits exceptional interlaminar bond strength and solder resistance. Its proprietary composition results in low moisture absorption and uniform electrical properties. Taconic CER 10 PCB has a board between each lam...

• January 04. 2023

As 5G Technology develops, more and more devices request high-performance high-frequency PCBs and RF PCBs that need low signal losses and low electrical noise. Rogers PCB materials are cost-effective and perfectly meets the required technological requirements. Rogers PCB is a type of high-frequency board that raw material is produced by Rogers company. It is different from the conventional PCB boa...

• January 11. 2023

Rogers AD250C - A New Microwave PCB Material Check out the Rogers AD250C if you're seeking for a new microwave PCB material. This dielectric-layered, ceramic hydrocarbon-based microwave high-frequency PCB material is reasonably priced. Let's examine this content in more detail. Why is it so successful? Let's proceed with it now. Insulating layer made by Rogers AD250C You can combine FR-4 and a rob...

• February 01. 2023

Rogers RT/duroid 6006 and 6010.2LM PCB PCB material is primarily used in electronic and microwave circuits. Its performance has a significant impact on the circuit system's signal transmission speed, energy loss, and characteristic impedance. Rogers Corporation, a well-known material supplier, has introduced RT/duroid 6006 and 6010.2LM, a high performance microwave PCB material. It is made of cera...

• February 14. 2023

Rogers RO3035 high frequency circuit materials are PTFE composites filled with ceramic and designed for use in RF and commercial microwave applications. It was created to provide mechanical and electrical stability at affordable prices. They boast circuit materials with consistent mechanical properties regardless of dielectric constant selection. This enables the designer to create multilayer boar...